Case story: Furnace rollers made from Kanthal APMT outlast conventional rollers by four times

By utilizing furnace rollers made from Kanthal® APMT, an iron-chromium-aluminum (FeCrAl) alloy, steel mills can boost productivity, reduce maintenance costs, retain a consistently high quality level and contribute to a cleaner environment.

The challenge

Newly installed furnace rollers at a Swedish tube mill produce approximately 200 tons of stainless steel tubes per week. With an estimated value of 10 euro per kilo of stainless steel, the mill's furnace rollers are manufacturing the equivalent of about two million euro per week.

Within two years of installation, four of the rollers started cracking at the welds and showed extensive oxidation, causing surface problems. To overhaul the furnace rollers, the owners needed to shut down the furnace, which cost their operation up to two million euro a week.

Many mills face similar challenges: the furnace environment causes excessive oxidation on traditional nickel-chromium (NiCr) alloy rollers. Consequently, furnace rollers can only be used six to twelve months before reconditioning. This means frequent maintenance stoppages as well as costly storage of large numbers of spare rollers.

Moreover, the rough and uneven surfaces formed on these furnace rollers can cause surface defects on the tubes. This produces a poorer yield and adds extra production costs. Furthermore, traditional rollers require a fair amount of water for cooling purposes, using higher energy and creating a less than clean environment.

The Sandvik solution

Sandvik is introducing furnace rollers made from Kanthal® APMT, an iron-chromium-aluminum (FeCrAl) alloy, that significantly outperform conventional NiCr rollers. Specifically, Kanthal® APMT is a powder metallurgical dispersion strengthened alloy that offers a unique combination of high creep strength and resistance to oxidation at high temperatures – critical for high-performance furnace rollers. It also features high mechanical strength at temperatures up to 1250°C (2280°F). These unique properties make Kanthal® APMT uniquely suitable for furnace rollers among a number of other high-temperature applications.

The result

An installation at a Swedish tube mill shows that furnace rollers made from Kanthal® APMT have a service life of up to four times longer than that of conventional furnace rollers. The new material, together with a new roller design, ensures a surface that actually improves the quality of the manufactured tube products.

By installing the new furnace rollers from Kanthal® APMT, the tube mill has also been able to reduce maintenance costs and increase productivity. Maintenance stoppages have been reduced significantly. In fact, since 2004 when the tube mill started utilizing furnace rollers made from Kanthal® APMT, the rollers have not only increased their service life by four times, they have reduced the need for storing spare rollers.

Stark comparison: Pictured left are nickel-chromium (NiCr) standard rollers after one year of service. Pictured right are rollers made from Kanthal APMT after four years of service.

Furnace rollers product page